Joystick Pitch Bend Flaw in the GAIA
28 Aug 2020, 05:15This synthesizer has been manufactured for about ten years, yet as I searched the web, I have not been able to find any information on what appears to be a flaw in the pitch bend control on the GAIA, yet I have seen it on two units. When I first bought my GAIA, I saw it had a slightly defective envelope slider control, so I was going to exchange it, anyway, but I also saw this flaw with the pitch bender. When I got the new unit, it did the same thing with the pitch bender, which makes me think that it is a design flaw, and not a defect on specific units.
This is the flaw: When I first turn on the GAIA, if I do a slow downward bend with the pitch bend joystick, it acts quite weird. It seems like the entire range of its bend it done in about the first 30 or 40% of the travel of the joystick, and when it is set for a long-range bend (such as an octave) and I move the bender slowly, I can hear the bend as a series of steps, almost like a glissando, instead of a smooth and continuous pitch bend. It only acts this way for the first downward bend that I do when I first turn on the synth. After that, all subsequent bends act normal until the unit is turned off and on again. Also, from what I can tell, I can "clear" this condition by just moving the joystick all the way to the left one time right after turning on the unit, even if I am not playing a note at the time.
Has anyone else noticed this? Granted, for the way the pitch bender is used much of the time -- just quick bends of a semi-tone or a whole tone -- this flaw would likely be barely noticeable. But I find it hard to believe that no one else has noticed this in ten years. Has anyone else seen this?
This is the flaw: When I first turn on the GAIA, if I do a slow downward bend with the pitch bend joystick, it acts quite weird. It seems like the entire range of its bend it done in about the first 30 or 40% of the travel of the joystick, and when it is set for a long-range bend (such as an octave) and I move the bender slowly, I can hear the bend as a series of steps, almost like a glissando, instead of a smooth and continuous pitch bend. It only acts this way for the first downward bend that I do when I first turn on the synth. After that, all subsequent bends act normal until the unit is turned off and on again. Also, from what I can tell, I can "clear" this condition by just moving the joystick all the way to the left one time right after turning on the unit, even if I am not playing a note at the time.
Has anyone else noticed this? Granted, for the way the pitch bender is used much of the time -- just quick bends of a semi-tone or a whole tone -- this flaw would likely be barely noticeable. But I find it hard to believe that no one else has noticed this in ten years. Has anyone else seen this?