All I can say if YOUR your power cord has an in-line fuse in it should be marked when you remove it to tell you AMPS @ voltage. What are the markings?
-----------------------------------------------------------
Before we go on please remember I’m using a 110 VAC USA XV-5080 unit and all I need is a standard 3-prong (unfused) cord. I can use any standard 3-prong cord like these and I actually do. I use a 3-foot one not the supplied 6 footer because unit it’s close to regulated power strip in rack
https://www.amazon.com/TNP-Universal-Power-Cord-Feet/dp/B01EYDGO12/ref=sr_1_3?qid=1555529146&refinements=p_n_feature_keywords_browse-bin%3A3606203011&s=aht&sr=1-3
Maybe the other cord sets, for units shipped to other countries, had in-line fusing (this is list from Service Manual page 7)
00894367 AC CORD SET 100V SP18A+IS14 VCTF2X0.75 1
00894378 AC CORD SET 120V SP301+IS14 SJT18/3 1 (NOTE this USA and like MINE it is NOT FUSED )
00894389 AC CORD SET 230V SP22+IS14 H05VV-F3G1.0 1
00907001 AC CORD SET 240VE KP-610 GTTBS-3 KS-31A 1
23495124 AC CORD SET 240VA SC-144-JO1 ES303-
10HMA
Now back to what you said, in general you do not NEED a fuse to “complete any circuit” you may need or want a fuse if you want to PROTECT a circuit that doesn’t have any other means of protection from internal unit over currents, shorts, etc. You may also DESIGN a circuit in such a way that it requires a fuse at some point in voltage path. But a fuses only purpose is to keep the unit from allowing too much internal destruction of unrelated circuits, or even too much destruction of the very circuit causing too much current draw.
I was going to take a picture of my XV-5080’s back to show it has no fuses there but no need – look at Users Manual page 14 – (diagram of back of unit is same as my unit) you can see there is NO FUSE, at least externally.
THE XV-5080’s power supply, is nothing more than a self-contained switching regulator takes 100, 115, 230, or 240 VAC and converts those AC voltages into DC: +15 VDC, -15 VDC and +5VDC. So any “protection” must be performed in that module – because in the schematics there are no fuses anywhere: see Service Manual. If you doubt me – open up your unit and look for fuses. BTW while you are in there you may want to remove and replace the CR2032 battery on Main Board– I’m sure it’s the original and WAY OVER 10 years old. However, make sure you back up your XV 5080 user memory first to external device like SM card.