This is documented (sort of) in the documentation which came with the X. It advises that the screen may need time to initialize to it's full brightness. Once it "warms up" (usually less than 10 minutes) it should stay steady.
Regarding the overall dim-ness of the display...what I have noticed is that the viewing angle of the F-X screen is very narrow in comparison to the F-S screen. There is about a 45 degree angle which you can look at the X screen and get it's best and brightest view, regardless of the contrast knob setting. And this 45 degree angle is very "high" over the board. You need to be sitting up (or standing) looking down over the board to comfortably be within this viewing angle. If you sit in front of your X, looking forward at it, you will likely be tettering on the edge of being outside this angle, where the brightness diminishes greatly.
You'll notice that the screen has been angled upward in the construction of the X, unlike the construction of the S where it is flat. This is not just a cosmetic or convenience feature. This is necessary to give you "any chance" of being in it's optimal viewing angle while sitting in front of the keyboard. Overall...this is less than optimal in my opinion. The S had much better viewing angle, and much better contrast control. Albiet, with grayscale graphics that are harder to interperet.
Pretty much any where I would sit in front of my X, I would find myself needing to lean forward uncomfortably to work with the screen. My ultimate solution was to place the X on an angled keyboad tier stand (at about a 45 degree angle, so with the screen already being angled, it is facing me directly), and now the X faces me dead on when I sit in front of it. I actually like this quite a lot not only for the best screen viewing, but for the ergonimics of editing and working with the board. But frankly, I found it almost unbearable when I had it sitting flat.
Thanks,
Ron