Fantom-S and Fantom-X

Control pedal skips live sets

Control pedal skips live sets

16 Jan 2014, 04:43
Hello everyone,

I have connected my hold pedal (Roland DP-10) as a control pedal on the fantom x6 to try out the "LIVE SET UP" mode. It is really useful for me as during a gig I sometimes miss the buttons with my fingers...

I noticed some strange behaviour though, and I was wandering if anyone else has experienced it. On the first bank (1-1 to 1-16), pressing the pedal goes from 1 to 8 like normal. If I press it while on 8, it jumps straight to live set 12! The next press takes it to 14, then 15 and then it refuses to go to 16...

I filled up the second bank just to try again and there, it takes me from 2-1 to 2-9 normally, and then it will not go any further (I have filled all slots with song files).

What could be the problem? I have tried both modes on the pedal (continuous and switch) as well as both polarities. Same problem always.

Re: Control pedal skips live sets

16 Jan 2014, 10:08
I haven't seen that problem but as a start I would make sure you have the latest firmware. What version are you using?

Re: Control pedal skips live sets

16 Jan 2014, 18:27
I'm using 2.10
It's the first time I have used this setting so I don't know if it was the same with the previous OS.
I think I'll try backing up everything to the CF card, then reset to factory settings. After that I'll fill up the slots with patches or songs before loading any of my data and try again.

Re: Control pedal skips live sets

17 Jan 2014, 19:49
OK so I tried factory resetting, and it still does the same thing...although after skipping to 1-12, it now goes all the way up to 16 and not just 15 like before. Any ideas? Could it be the pedal? As far as I know a sustain pedal is a simple momentary on/off switch.

EDIT: Loaded my user data again. It now goes 1,2,3,4,5,6,7,8,12,13,15 and stops there...

HALP

Re: Control pedal skips live sets

22 Jan 2014, 15:36
Hmmm, I dont get it. I dont think it is the pedal as the sustain pedal is just, as you suggest, a momentary pedal. They is obviously something buggy here....I know, not helpful. I don't have my X anymore although I have access from time to time and I will try and remember to test it next time I have access to an X. Perhaps someone here can try it out on their x for you, fixxxer113.

Re: Control pedal skips live sets

16 May 2014, 02:20
After a loooooong wait due to some problem with the local Roland distributor, I finally received the DP-2 and the result is the same...

I now have a very sad face :(

Does anyone know if there is a sysex command for the LIVE SET UP/DOWN function? Maybe I could do it through RPS or a MIDI foot controller...

Re: Control pedal skips live sets

16 May 2014, 09:30
I dont think it's the pedal. Also, I tried it myself on an F6 and it worked fine so I don't think is any kind of software bug.

I dont think there is sysex that will do it either. I tried recording the LIVE SET UP into RPS and nothing was recorded so it is an internal command...not the answer you were looking for.

When you did a factory reset did you then load your patches or performances to test it or did you use the factory patches / performances?

You might also want to set the pedal to Prog Up and see if that works. I guess we are unsure if it is something physical inside the jack perhaps or in the software.

← Back to Fantom-S and Fantom-X