Hi miketrax.
Welcome to the Roland Clan.
If you are using the LOOP (POINT) setting in the Realtime Rec Standby window, any value you set for the loop point there applies to playback as well. Record and playback modes do not have separate loop points. If you have the LOOP (POINT) option turned on, it is not possible to begin recording at any other point than the loop start point. However, you can use the "Rehearsal" function while recording. This is functionally the same as a manual punch-in and punch-out. While recording with the LOOP (POINT) parameter set, either press F7 (Rehearsal) or press the REC button. In either case, the REC light will begin blinking and the "Rehearsal" button on the screen will glow red while playback continues to loop. Nothing you play will be recorded but can still be heard. Just before you get to the point at which you wish to record press the F7 "Rehearsal" or REC button again. The REC light will go solid again and the "Rehearsal" button on the screen will return to grey indicating that everything you play is now being recorded. Begin performing what you wish to record. The sequencer will continue to loop as many times as you set in the Realtime Rec Standby window and you can enter and exit the "Rehearsal" mode at any time during recording. See page 173 of the Fantom-X Owner's Manual (assuming you have a Fantom-X).
Regards,
Nathan Sheldon
http://www.nathansheldon.com/