Split problem (no.2)
16 Dec 2014, 08:21Hey everybody,
First i like to say that i really like my Fa 06, i can play for hours and hours on this machine.
I bought it to replace my Fantom Xa, which is heavy, for gigs. The workflow on the Fa is very similar to that on the Xa so that was a great advantage for me too...never had to check the manual yet.
But....... i recently found out that there is (at least for me ) an issue with the splitting in a Studioset i never encountered on my XA. I wanted to create a studioset for my Reggaeband, and be able to switch sounds, while playing a constant sound with my left hand in the lower keyrange. BOOM!!!! Keyrange can only be set if you place the part in the mix, with the KBD switch highlighted. Where on my Xa you could create a Performance, set individual keyranges for the parts, and then switch between them.
I could cycle between the parts, set to different keyranges, and at the same time have a lower part on with my keyswitch(on/off) option. On the Fa this results in a layer. The selected part, if kbd not highlighted, uses the whole keyrange and not split with the lower part, who must be highlighted too. In order to get the result i want, i have to constantly switch kbd on and of before switching sounds. I tried changing the keyranges in the tone edit area, but this doesn't work either. I hope you guys understand my writing.
Anyone else here who encountered this "flaw'????
First i like to say that i really like my Fa 06, i can play for hours and hours on this machine.
I bought it to replace my Fantom Xa, which is heavy, for gigs. The workflow on the Fa is very similar to that on the Xa so that was a great advantage for me too...never had to check the manual yet.
But....... i recently found out that there is (at least for me ) an issue with the splitting in a Studioset i never encountered on my XA. I wanted to create a studioset for my Reggaeband, and be able to switch sounds, while playing a constant sound with my left hand in the lower keyrange. BOOM!!!! Keyrange can only be set if you place the part in the mix, with the KBD switch highlighted. Where on my Xa you could create a Performance, set individual keyranges for the parts, and then switch between them.
I could cycle between the parts, set to different keyranges, and at the same time have a lower part on with my keyswitch(on/off) option. On the Fa this results in a layer. The selected part, if kbd not highlighted, uses the whole keyrange and not split with the lower part, who must be highlighted too. In order to get the result i want, i have to constantly switch kbd on and of before switching sounds. I tried changing the keyranges in the tone edit area, but this doesn't work either. I hope you guys understand my writing.
Anyone else here who encountered this "flaw'????