Fantom-S and Fantom-X

Help.... Control Pedal Problems

Help.... Control Pedal Problems

10 Jul 2012, 17:51
Hope somebody can help me here.....

I've been using a Roland EV5 control pedal with my X7 for various jobs depending on the patch - Leslie on/off, modulation on/off, volume up/down, etc. It was working fine until recently when it's started to switch the desired effect on but won't turn off again. e.g., rock it down on a hammond patch to turn on the Leslie effect and rock it back again and the Leslie stays on.

I've tried everything I can think of including checking the control number in the System page (I've tried swapping between expression and CC#11, standard and reverse, to no avail). After trying everything I could think of, I purchased a brand new pedal. Set it up and low and behold, the problem remains.

So, either there's another setting in the X7 I've missed or there's a hardware fault on the jack socket somewhere.

Does anybody have any ideas? It's really frustrating and compromises many of the patches I need for live gigs. Any ideas gratefully recieved!

Re: Help.... Control Pedal Problems

11 Jul 2012, 00:02
Sounds like a EV failure.
If you have a meter that can measure resistance check the following.
There are 3 metal pieces on the plug - tip ring and sleeve.
As I recall...
Measuring between the sleeve and the tip, moving the pedal should change the resistance.
Measuring between the ring and the tip, moving the pedal should change the resistance but in the opposite direction.
Measuring between the sleeve and the ring, moving the pedal should not change the resistance.

Royce

Re: Help.... Control Pedal Problems

11 Jul 2012, 01:54
Royce, thanks for the reply. I'll check this but it doesn't explain why the brand new pedal still does it. I'm leaning towards an issue inside the X7, either something wrong in the configuration somewhere or a hradware fault on the board. What do you think?

Thanks

Re: Help.... Control Pedal Problems

11 Jul 2012, 08:29
The fact that it is switching on the Leslie means it must be outputting something.
There isn't much in these type of controls. Usually just a pot - like a volume control .
You might like to look at the Midi data coming out of the FanX when you move the pedal .
If you have a PC, check with MidiOx. You should get the full range of values from 0 to 7F (127)
The usual failure is the cable or plug especially if you use it live.
A crushed/pinched cable under a keyboard stand or chair can do it or the cable pulled and stretched is also common way to break them.
Open up the pedal and check all three connections to the tip ring sleeve - usually 2 wires and a braided shield.

Re: Help.... Control Pedal Problems

11 Jul 2012, 15:37
Have you tryed the "Polarty Switch" on the Pedal and making sure that the "Min" dial is all the way down?.

← Back to Fantom-S and Fantom-X