Fantom-S and Fantom-X

assigning music to pads in the pad bank

assigning music to pads in the pad bank

9 Aug 2004, 08:07
I am constantly amazed at the capabilities of my new FX7. One thing I think might be possible, but I have figured out yet, is to be able assign parts of a song to various pads in the pad bank.

What I want to be able to do is to put the chorus to a song on one pad, the verse to another pad, and the bridge to another pad. On these pads would be drums, bass, strings, etc., and I would play the piano over the top of them. If this could be done, then I could lead songs with more flexibility, going back to the chorus when I wanted, repeating a verse, etc. I have been able to sequence entire songs, but it is so rigid and does not allow for spontenaity.

Is this possible? Any tips or suggestions would be greatly appreciated.

Re: assigning music to pads in the pad bank

9 Aug 2004, 11:31
Yes it is. Look on the manual for RPS ( realtime phrase sequencing ).
I don`t have the FS OR FX, just the original fantom, but is a similar process, I think.
hi bigbarry,

sequence the parts in the Pattern mode. then assign the patterns to the pads using the RPS function. check the Sync button to Measure or Beat.

press let the sequencer play and u can keep jamming with the pads. also remember that the sequencer needs to be either recording or playing - it needs to be active in order for the sync function to work..

i am stating all this with respect to my Fantom-S. in FX i guess its 99% similar.

Sambasevam.S


---------------------------------------------------------------
If at first you dont succeed, then skydiving is definitively not for you.

Re: assigning music to pads in the pad bank

9 Aug 2004, 19:57
Thanks for your replies.

I am feeling pretty stupid because I am unable to get the basic RPS function to work, let alone do with it what I intend to do as stated in the first post of this thread.

I can record music into the system using the Record button. When I press play it plays it back. But I can't seem to get it to be assigned to a pad (or a key) using the RPS function.

I follow the steps in the manual, but the pad ends up empty. What I don't see is how does the music get from the sequencer into the pad? There is an RPS setup process, but it does not seem to indicate where or how the sequence gets grabbed and assigned to a pad.

I can play with the play button, but the pad does nothing. Any suggestions?

Thanks.

here goes...

10 Aug 2004, 10:27
in all the following instructions, i refer to the FS. i assume that FX is similar to it, except for some names...

press the sequencer/song edit button.
press F2 (Pattern)
press REC
play something
press PTN NAME
give it a name if u want
press SHIFT+RPS
assign PAD1 to PATTERN 1 (or whatever name u give)
assign SYNC to BEAT
press EXIT
press F2 again
the mode is in song edit now.
see that the RPS light is ON (very important)
press PAD 1
you should hear what u recorded


after doing this, if u have futher probs, blast away.. i 'm hooked up to help...:-)

Sambasevam.S


---------------------------------------------------------------
If at first you dont succeed, then skydiving is definitively not for you.

Re: assigning music to pads in the pad bank

10 Aug 2004, 17:08
Thank you, thank you, thank you.

I wasn't recording the music into a pattern. That was what I was missing. Thanks again for your help.

Re: assigning music to pads in the pad bank

11 Aug 2004, 15:53
no prob...always hooked up to help.. :-)


Sambasevam.S


---------------------------------------------------------------
If at first you dont succeed, then skydiving is definitively not for you.

Can't find RPS

24 Aug 2004, 21:55
Hi - I've followed samasevam's advice below and (of course) looked in the manual too... BUT

I get as far as pressing shift+RPS, but can't find RPS.... should this come up as an option above the function buttons? Is it a button somewhere else on the fantom that I'm missing.

I'm sure it's real obvious, but I just can't find RPS anywhere...

Hope someone can help.

← Back to Fantom-S and Fantom-X