Fantom-G

How to undo "Latch mode" on sliders and knobs?

How to undo "Latch mode" on sliders and knobs?

13 Jun 2010, 10:12
Ok one of the quirks that I now have on my fantom since the 1.5 upgrade is that wherever the preset levels are for anything that is adjustable by the sliders or knobs is in a "Latch" type of mode. This is most likely how 99.9% of the world wants it but I am that 0.01% that thinks this is aggravating as hell. When I move my sliders I want the levels to adjust where I am moving them immediately,NOT to have to turn the knob or move the slider to the point that the preset is set to THEN move them down or up...

There HAS to be a way to turn this off... I just can't find it.

Help?

I am attaching a poor picture but my camera just doesnt seemt o want to take a clear picture... hopefully you can see what I mean on slider # 2 in the picture.

Re: How to undo "Latch mode" on sliders and knobs?

13 Jun 2010, 10:24
The is a system setting for knob slider mode.

I not at the keyboard (so hang in there I may miss a step)

1. Press Menu
2. Select System
3. Hit F3 Setup
4. Select Knob/Slider
5. Change value from "Catch" to "Direct"

when this fails try reading page 289 back to 286 of the manual. You have to do a "System Write" to save this configuration.

Good Luck
Fantom G & X7, Motif XS6, M3, V-synth, JP8000, M1, Wavestation, Radias, Nord Lead 2X, Karma, Snow, electribes and other groove boxes.

Re: How to undo "Latch mode" on sliders and knobs?

14 Jun 2010, 15:55
While "Catch" and the "Direct" work fine, what is "Multi"?, seems to act just like "Direct".



THIS IS A 1.30 UPDATED FEATURE

MULTI: The knobs, sliders, D Beam, and S1/S2 buttons will simultaneously control multiple parts (each part whose Keyboard switch is on). The Knobs abd sliders will operate in the same way as "DIRECT"
Fantom G & X7, Motif XS6, M3, V-synth, JP8000, M1, Wavestation, Radias, Nord Lead 2X, Karma, Snow, electribes and other groove boxes.

← Back to Fantom-G