Fantom-G

setting midi up to logic express

setting midi up to logic express

25 Dec 2009, 19:27
hi im new to this, just opened up my fantom g6 today!its amazing!
just need help with setting up the fantom to my macbook as i wanna run it thru logic express 8.
ive connected the usb going direct into the computer connection on the keyboard.
but am not getting no signal in logic what else do i have to do? thanks.

Re: setting midi up to logic express

26 Dec 2009, 02:33
First you need to install the Fantom-G USB driver on your Mac. Next, connect the G to your Mac with a USB cable, turn both on, launch the Audio/MIDI Setup application from the Utilities folder, add a new device and connect it to the Fantom-G driver. From this point you'll see it appear as MIDI in/out and audio in/out everywhere where this is supported.

Re: setting midi up to logic express

26 Dec 2009, 07:51
thanks all done have now set it up.
ive noticed it only works on the logic in Live mode (on the fantom) when i hit the keys but am also notcieing im getting like 2 sounds playing at once. like ive got piano playing and u can hear brass too! am confused. i tryed studio mode but get no sounds.
i just wanna lay down diffrent sounds on logic please help

Re: setting midi up to logic express

26 Dec 2009, 07:58
Switch to single mode, and select the "external" part.

Re: setting midi up to logic express

26 Dec 2009, 09:10
wicked all sorted thank u again.
how do i now save the sounds i like for building a track for eg track 1 is piano then i want track 2 bass etc, track 3 strings etc. ?i have no idea help
thank you

Re: setting midi up to logic express

26 Dec 2009, 09:27
It depends on what sounds you want to work with. If you want to make a song using Fantom-G's sounds, just go into Studio mode and select the internal mixer page. In there you can select all your sounds for each part (MIDI channel). You'll also need to set the effect sends for chorus and reverb and so on. If you want to work with plugin sounds in your logic, then you'll need to go into Logic and select these sounds. In order to make it possible for the Fantom-G to control Logic's sounds, you need to switch the Fantom-G's Studio mixer to the external page. Back to your Mac, you'll need to install the USB driver for your Fantom-G, so they'll communicate with each other once you connect them with the USB cable. Finally, you'll need to select the Fantom-G as a MIDI input device in Logic's settings, plus in each track you need to assign the Fantom-G as the MIDI input, selecting the corresponding Fantom-G's MIDI channel to which they will respond. After that, you'll be ready to record some tunes.

Re: setting midi up to logic express

26 Dec 2009, 10:03
hello yes i want to use the fantom-g sounds to make a song in logic. i have install the usb driver already.
ive now gone into studio mode and selected the internal mixer page.
but how do i select each part midi channel to assign with the logic so i can record.
thanks

← Back to Fantom-G