GT 2.0 aftertouch
4 May 2009, 05:37Hi,
anybody can tell me how I can reliably test aftertouch, I dont get this to work, at all.
so far I tried like this. In common patch settings there is a tab 'Matrix Control'. Then in one of the 2 control boxes where you can select the source, I put in 'AFT'. Then I put the destination to OSC1- PITCH with controller sensitivity set to maximum. I chose pitch with a basic saw analog osc setup on osc 1 because this would be the easyest to hear.
Also in the main keyboard setup I turned aftertouch sens tot 200 and velocity to real
but I hear no difference from pressure on the keyboard, not even to the point where it looks like I would break somethring if I press it any further?
is my GT broken ??
anybody can tell me how I can reliably test aftertouch, I dont get this to work, at all.
so far I tried like this. In common patch settings there is a tab 'Matrix Control'. Then in one of the 2 control boxes where you can select the source, I put in 'AFT'. Then I put the destination to OSC1- PITCH with controller sensitivity set to maximum. I chose pitch with a basic saw analog osc setup on osc 1 because this would be the easyest to hear.
Also in the main keyboard setup I turned aftertouch sens tot 200 and velocity to real
but I hear no difference from pressure on the keyboard, not even to the point where it looks like I would break somethring if I press it any further?
is my GT broken ??
i have also tried with a midi dumper i dont see any aftertouch midi commands either.. not sure if it sends them anyway tho