Fantom-S and Fantom-X

RAM board doesn't fit. ARRGHHHHHHH

RAM board doesn't fit. ARRGHHHHHHH

19 Jul 2007, 11:15
Just got me some RAM(PC 133),and the frigging thing won't fit-(the indentations on the DIMM board are too high for the white locking clips to pass over).Has anyone else had this problem?Is there anything i can do,or have i just blown £40:-(
In the manual it says the expansion memoery boards should be 38mm in height or less;is this where i've f***ed up?

Re: RAM board doesn't fit. ARRGHHHHHHH

19 Jul 2007, 17:22
Lift RAM.

Rotate 180 degrees.

Lower RAM.

Just covering the obvious, I just dug a spare 128mb stick out of a box and stuffed it in no problem.

Re: RAM board doesn't fit. ARRGHHHHHHH

19 Jul 2007, 17:43
Tried every which way but loose man.No probs getting it in there,but i can't lock it with the clips.Darn it!

Re: RAM board doesn't fit. ARRGHHHHHHH

19 Jul 2007, 19:25
Did you buy the proper RAM ? should be non ECC..type SD RAM

------------------------------------------
Image
VEN KIEE
Fantom X6 (fully maxed)....Triton Extreme....Edirol MA-15D monitors....Soundcraft Compact 10 mixer....
Tascam FW1804....Sonar 6....Reason 3....
------------------------------------------
[IMG]http://img.photobucket.com/albums/v149/paul24/palpatinehologram.gif[/IMG]
VEN KIEE
Fantom XR (fully maxed)....Korg M3.....Tascam FW1804....Cubase 5....Reason 4....

Re: RAM board doesn't fit. ARRGHHHHHHH

20 Jul 2007, 00:37
Yep,

Typically ECC memory has a few extra chips on there causing the DIMM to be a bit wider.

----------------------------------
Fantom X8 (2.10) 512MB
Fantom XR (2.02) 512MB
V-Synth XT (2.02)
SH-201

Re: RAM board doesn't fit. ARRGHHHHHHH

20 Jul 2007, 04:13
ECC non-ECC...it's all double dutch to me!All i know is that it's a 168 pin,sdram,dimm,pc133 board.
Thanks for your replies anyhow(sigh):(

Re: RAM board doesn't fit. ARRGHHHHHHH

20 Jul 2007, 17:44
Was it just a matter of not having pushed hard enough to seat the board properly? If you do this sort of thing infrequently, it is really hard to judge the proper amount of force.

-Ron

Re: RAM board doesn't fit. ARRGHHHHHHH

21 Jul 2007, 08:23
did you try to use hammer?
simple tool, but it helps sometimes.

Re: RAM board doesn't fit. ARRGHHHHHHH

21 Jul 2007, 14:47
Yeah,i had to really force it.I wasn't sure how much stress the RAM boards could take.

Re: RAM board doesn't fit. ARRGHHHHHHH

23 Jul 2007, 00:36
Ahh yes. When I upgraded my XR and X8, the board actually bent a little while I was getting the damn thing in. Scared me to death but it did go.

Glad it worked out for you.

----------------------------------
Fantom X8 (2.10) 512MB
Fantom XR (2.02) 512MB
V-Synth XT (2.02)
SH-201

← Back to Fantom-S and Fantom-X