Fantom-S and Fantom-X

How do I make a part in a Performance sound the same as when

How do I make a part in a Performance sound the same as when

20 Jun 2004, 08:43
OK. I play the Piano (Concert Piano) in Patch Mode. I make a Perfomance and i sound not like the same. Iread the http://fantomized.info/faq/FantomSX-Newbie-FAQ.html 3.1 and i do so.. The piano in perfomance (seems?) sounds like in the patch Mode. OK
Now i do the same with an accordeon sound and it sound NOT like the same. I must switch the revberb about 20 more than in the patch?

I hope you understand my very bad Englisch (im from Germany)

Is is really possible to make a performance where the patches sounds like the same?? Perhaps i make i mistake.

I hope you can help me

Re: How do I make a part in a Performance sound the same as

20 Jun 2004, 18:48
Performance and patch EFX are different, so you need to set up your Performance EFX to match what is programmed into the performance. If you use a multi-patch performance, that is not always possible, but for say a Bass/Piano split, you can get the job done.

Re: How do I make a part in a Performance sound the same as

21 Jun 2004, 02:34
It's that performance part has reverb and chorus sends that are stored in performance itself, and probably are not affected by the SRC thing. Also, reverb and chrorus settings can be loaded from a certaib part using the SRC method too.

You should also remember that there are only 3 MFX and you have to share them across 16 parts (patches).

Re: How do I make a part in a Performance sound the same as

21 Jun 2004, 09:58
Thanks a lot. Is ther no possible to copy the EFX from a patche to a part in a performance?

← Back to Fantom-S and Fantom-X