Problem using volume pedal in performance mode

In the performance edit screen, there is a MIDI filter where you can switch the expression pedal off on the parts that you do not want to respond to it.

Thanks for the prompt reply.
I will try what you suggest but looking at it I do not think it will help what I need

I'll explain further

I want all 4 parts to alter in volume with the pedal. I want them all to go quiet and then all to become louder when required but only back to their preset various volumes.
When I first press the pedal all the sounds instantly become set at the volume the pedal is moved to.
Parts 1 2 3 and 4 all output the same volume. Ie if I take part one to the original 110 all the other patches follow suit and are also set at 110

Do I need to take the pedal of it's volume setting and use it as so
ething else ? Expression or other. I'm not sure on the tech terms.

It looks like the pedal adjusts the absolute level, not relative... Maybe there is some setting for that in the system settings, not sure. What I would do is use the control matrix in each patch to assign the pedal to the level, then you have control for the depth of modulation for each patch.

Thanks I'll try that also

I just wanted to alter the output volume of a saved performance as though is was turning the volume dial rather than edit the programming settings during playing live.

It's my first real night of using the new keyboard so maybe i'll figure it out with your help and realise how easy it was to do.
Many thanks.

Rusty, can you set the volume pedal to control Master Volume? If not, try using it to control the Expression CC instead of Volume.

Regards
Andy

Good point, Andy!