Fantom-S and Fantom-X

Panning Issue

Panning Issue

27 Dec 2006, 12:57
Most recently, I've been realizing that when I record my tracks to the computer (Nuendo), the right channel is always noticeably louder and fuller than the left channel (20-25%). I know that some instruments are panned left or right but this happens to everything...even samples that play in mono. I went through the manual and I didn't see anything to the effect of panning on the master channel.

I even tried turning the mastering compressor off to see if maybe one channel was being compressed more than the other but that didn't work.

Image
Only Mike is HERE!!!
...oNe...
Disregard this post. I just realized that the left audio cable was plugged into the headphone jack (not the left audio output).

I should've known from dealing with computers that the first thing to do is check the connections when something isn't working right!

Thanks anyway!

Image
Only Mike is HERE!!!
...oNe...

Re: Panning Issue

27 Dec 2006, 13:00
Do you use analog cables to record the Fantom? If so, are they of the same kind? If one of them is longer and is of lower quality materials it may attenuate the signal a bit.

YOUR MIKE IS HERE LINK IS DEAD

27 Dec 2006, 18:32
From one mike to another.....I thought you should know! ;-}

Thanks again...

28 Dec 2006, 03:00
Plug was in the headphone jack (that's why you don't let anybody f with your setup!!! lol).

Good lookin' out for the heads up about the link too! =o)

...oNe...
...oNe...

← Back to Fantom-S and Fantom-X