V-Synth

zipper sounds and touch screen issues

zipper sounds and touch screen issues

26 Jul 2005, 16:15
hello,

I just received my v-synth yesterday. The only other digital synth I own is the monomachine from elektron. On many of the sounds when using the on screen time-trip I notice a zippering effect. It may be that the touch screen is not registering my whole motion but it doesn't seem to respond fluidly. Which leads me to my next concern. The touch screen seems to not react how other touch screens I have used before have. I have done the calibration, but sometimes I have to press the button two or three times and sometimes very hard. Toward the corner of the screen it seems to react the worst. Any suggestions or anyone notice the same thing. It is the same with the stylus I use or my actual finger. Lastly, one small thing that is annoying me is that if i change a value with one of the assignable pots, and it already has a setting it changes abruptly to xero again. Is there a setting for pass-through, where it waits for you to get to the original setting before changing? I have looked but not found one yet. Thanks in advance to any and all answers about my concerns and questions.

Mark

small records can make big sounds
small records can make big sounds

Re: zipper sounds and touch screen issues

27 Jul 2005, 09:00
I have actually pinpointed the area of the touch screen that does not respond. On the lower buttons (osc 1, 2 cosm 1 &2, exit, etc) if I press them from just below the halfway point to the bottom, they don't respond, it is like they are not being touched. But anywhere north of there they work perfectlt. At the top of the screem though, it responds fine all the way to the edge. Anyone else with a vsynth XT that uses a stylus, can you confirm this. If I have a defective touch screen I want to return it for a new one. If this 'dead area' is common, I guess I will just learn to live with it. I would appreciate the feedback, thanks.

small records can make big sounds
small records can make big sounds

Re: zipper sounds and touch screen issues

27 Jul 2005, 09:10
when i just got my vsynth xt , the touch screen was also not working fine. The only thing i needed to do was to calibrate the screen again, from that moment on, everything was fine.

The timetrip pad is indeed less responsive. i have the same problem as you describe. The screen doesn't seem to work quite well for that purpose.

_____________________
To hear my songs please check my website.
_____________________
To hear my songs please check my website.

Re: zipper sounds and touch screen issues

27 Jul 2005, 09:22
This sounds just like my XT also. A combination of re-calibration and practice help a lot but make sure you are running o/s 2.01. The later o/s seemed to make a difference but not clear whether this was a listed fix. Do it anyway (if you haven't already) and see if you get a difference.
All in all the touch screen response IS a little flawed in areas so I very much doubt you have anything wrong with your unit.

Re: zipper sounds and touch screen issues

27 Jul 2005, 09:27
Thanks, it is good to know I don't have a faulty unit but it kind of sucks to not have a more perfect real time controller, it makes me wish I had room for another keyboard.

I have recalibrated it multiple times, but it still has this 'dead area' near the bottom of the touch screen. I have also already installed os 2.01 but I did that right away after receiveing the unit so I don't know if the response was the same in this 'dead area' before. I am going to write to Roland Tech support and see what they have to say.

small records can make big sounds
small records can make big sounds

Re: zipper sounds and touch screen issues

27 Jul 2005, 09:29
are there still issues with the 2.01 firmware when you use the vc2?

_____________________
To hear my songs please check my website.
_____________________
To hear my songs please check my website.

Re: zipper sounds and touch screen issues

27 Jul 2005, 09:35
What do you mean by issues? I have not really used the card yet. I have switched to it and all seems fine. I tried out a couple of the 'keyboard models' and I installed the new tonee patches to my user bank, but I have not hooked up a mic yet. I was planning on doing this tonight. If there is anything specific you want me to look/check for, I would be happy to and i can confirm/deny any issues you may have or possibly have heard of. Just let me know specifics and if this would help you at all.

mark

small records can make big sounds
small records can make big sounds

Re: zipper sounds and touch screen issues

27 Jul 2005, 09:40
in this thread V-Synth OS update 2.01 someone mentioned the following problems

problems!!
the vocal card screen goes into a wild state when you try an turn through the patches after i updated the xt to 2.01

problems!!
Touchsceen a bit less responsive on osc selection tabs in v-synth mode.....kinda slow to go between osc1 properties and osc2. ......man!


That's why i just haven't upgraded yet. So if someone can confirm that these issues are non existant for most users that i will upgrade.

_____________________
To hear my songs please check my website.
_____________________
To hear my songs please check my website.

Re: zipper sounds and touch screen issues

27 Jul 2005, 09:42
robinez - confirmed !

Re: zipper sounds and touch screen issues

27 Jul 2005, 09:43
ok, i will upgrade tonight :)

_____________________
To hear my songs please check my website.
_____________________
To hear my songs please check my website.

← Back to V-Synth