V-Synth

Harmonic encoding problems

Harmonic encoding problems

29 May 2005, 08:28
Hi there - long time lurker and sometime poster here. Question for users of this marvelous synth - has anyone had strange pitch problems when encoding sounds with severe harmonic shifts?

I've been trying to meticulously sample and encode my beloved PPG Wave 2.3 and Microwave-1 wavetable sweeps to share with everyone here, but am encountering problems with several wavetables. Especially ones with radical harmonic transitions. Whenever certain sweeps are sampled, they sound just fine until I encode them. Then, as the areas with greater amounts of harmonic shift occur, the pitch will go wild - either jump up/down or sound like a speaking insect being crushed underfoot. I've tried alternate encoding types and have dabbled a little bit with altering the event markers - adding and moving them a bit. None of these seem to rectify this issue.

Anyone else having this type of problem? Any tricks or tips?

Re: Harmonic encoding problems

29 May 2005, 13:08
Events will not help you, they are just for playing the wave in one of the two available "chopped" modes.

If your wave doesn't sound good with any of three good encoding types (Solo, Ensemble and Backing), there is simply nothing you can do about it. You have no encoding options, and thus you have to try to find the material that can be encoded successfully. Please note that with today's usual technologies it is really not possible to analyse all types of complex signals and VariPhrase them perfectly.

Re: Harmonic encoding problems

2 Jun 2005, 14:37
Hello,

The encoding of Wave 2.3 samples you get will also have to do with the mod source you use to sweep the wavetable, and
the wavetable itself.
If your source controller for wavetable mod is stepped, and you use it with waves in which there is a weak fundamental with stronger upper harmonics, the pitch will appear stepped, along with the timbre. (Check out Sound-on-Sound's Microwave article)
You may want to try sampling other wavetables, using a controller that allows smoother transitions between waves. Carbon 111 also has charts of the PPG waves, which would allow you to select your waves based on harmonic structure in a visual manner if needed.


Regards,


LWG

Re: Harmonic encoding problems

4 Jun 2005, 08:30
Thanks for the input. Yes - I'm finding it easier to just use the Microwave and setting the wavetable wavemode to smooth, instead of stepped. Still, I'm coming to the realization that some of the wavetables just don't work well at all. The 2.3 is especially bad, probably due to the stronger sound. The pitch just doesn't work out right - goes haywire.

However, I have been able to recreate a few very nice patches that I will soon be posting - some very classic sounding sweeps which I hope you'll all enjoy.

Re:Harmonic encoding problems

29 Sep 2005, 06:49
Hi

i think i'm having a similiar problem with vocals a little.Regards wavetables i have the full set from a wavestation and also alot of the ppg and xt stuff and was planning on also doing this.Whats the best way to do this? create a crossfaded wav of a whole bunch of table waveforms and then load as 1 wav for encoding .In theory i guess you could then create a massive table or wavform which allowed lots of potential for weird stepping modulation and also smooth morphs ?

cheers

jachin

← Back to V-Synth